Folding Forum

Posted: **Sat May 09, 2009 9:45 pm**

Note 250002 steps vs. 250000.

Is this a "defective" WU?

Should I expect it to run to successful completion?

May I request a relatively quick and definitive response from someone who has accurate information please?
If defective, an acceptable remedy would be appreciated.

Code: Select all

[21:14:54] Project: 2669 (Run 15, Clone 6, Gen 135)
[21:14:54] 
[21:14:54] Assembly optimizations on if available.
[21:14:54] Entering M.D.
[21:15:05] Completed 0 out of 250002 steps  (0%)
[21:29:08] Completed 2501 out of 250002 steps  (1%)

Thank you, as always.

Posted: **Sun May 10, 2009 12:24 am**

This doesn't look defective. 2669 usually have 250,000 steps. Sometimes that varies by +/- a few. Defective WU's usually have 2x, 3x, etc. the number of steps.

Posted: **Sun May 10, 2009 3:16 am**

OK, I'm currently running 2669 R9 C135 G132 it also reads 250002 steps, was about to post this same question.
Is this common on 2669's ? Have only just started using the SMP client.
kiore.,

Posted: **Sun May 10, 2009 4:01 am**

We'll let her run (as planned anyway) and see if our friendly Guru is correct (as usual).

Thanks, Peter.

Folding Forum

Project: 2669 (Run 15, Clone 6, Gen 135) [250002 steps]

Project: 2669 (Run 15, Clone 6, Gen 135) [250002 steps]

Re: Project: 2669 (Run 15, Clone 6, Gen 135) [250002 steps]

Re: Project: 2669 (Run 15, Clone 6, Gen 135) [250002 steps]

Re: Project: 2669 (Run 15, Clone 6, Gen 135) [250002 steps]