Page 1 of 1
Project: 6504 (Run 18, Clone 36, Gen 15)
Posted: Sun Aug 08, 2010 6:02 pm
by Brambler
Code: Select all
[13:49:47] Completed 165000 out of 250000 steps (66%)
[13:54:13] Gromacs cannot continue further.
[13:54:13] Going to send back what have done.
[13:54:13] logfile size: 8314
[13:54:13] - Writing 8850 bytes of core data to disk...
[13:54:13] Done: 8338 -> 3181 (compressed to 38.1 percent)
[13:54:13] ... Done.
[13:54:13]
[13:54:13] Folding@home Core Shutdown: EARLY_UNIT_END
[13:54:17] CoreStatus = 72 (114)
[13:54:17] Sending work to server
[13:54:17] Project: 6504 (Run 18, Clone 36, Gen 15)
[13:54:17] + Attempting to send results [August 8 13:54:17 UTC]
[13:54:17] - Error: Could not read results file work/wuresults_00.dat from disk
[13:54:17] - Error: Could not read unit 00 file. Removing from queue.
Getting this same error at 66% repeatedly on this WU, other WU's that slip in once in a while complete just fine, but I keep getting this one over and over... fails at 66% every time and then cannot submit data.
Re: Project: 6504 (Run 18, Clone 36, Gen 15)
Posted: Sun Aug 08, 2010 6:22 pm
by sortofageek
There is no data back on that one yet. Given the error message, I think I would want to check the disk, particularly if I kept having issues like that.
Re: Project: 6504 (Run 18, Clone 36, Gen 15)
Posted: Mon Aug 09, 2010 11:53 am
by Brambler
It finally did send after making it to 68% the final time, since then several other WUs have completed.
Re: Project: 6504 (Run 18, Clone 36, Gen 15)
Posted: Mon Aug 09, 2010 3:29 pm
by sortofageek
The WU (P6504,R18,C36,G15) has been reported as a bad WU.
Thank you for the report.